Exhaust System (G1086743): Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).
-
WARNING:
- Make sure to support the vehicle with axle stands.
- Observe due care when working near a hot exhaust system.
Raise and support the vehicle.
- Refer to: Air Deflector (Front End Body Panels, Removal and Installation).
- Refer to: Engine Rear Undershield (Front End Body Panels, Removal and Installation).
-
CAUTION: Make sure that the exhaust system is supported with suitable retaining straps.
Torque Specification: 40 Nm
Torque Specification: 40 Nm
-
CAUTION: Make sure that the exhaust system is supported with suitable retaining straps.
-
CAUTION: Make sure that the exhaust system is supported with suitable retaining straps.
Torque Specification: 30 Nm
-
CAUTION: Make sure that the exhaust system is supported with suitable retaining straps.
Torque Specification: 6 Nm
-
NOTE: Do not disassemble further if the component is removed for access only.
Torque Specification: 48 Nm