Pinpoint Test G: Localization Failure
- G1: CHECK FOR ADDITIONAL DTCS
- G2: CHECK FOR ADDITIONAL DTCS
- G3: CHECK INITIATOR INSTALLATION
- Check for correct installation of Initiator. Refer to:
Tire Pressure Monitoring System (TPMS) Front Antenna (Removal and Installation) and
Tire Pressure Monitoring System (TPMS) Rear Antenna (Removal and Installation) .
Is the Initiator correctly installed?
- Yes : GO to G4 .
- No
: Rectify as required. Refer to:
Tire Pressure Monitoring System (TPMS) Front Antenna (Removal and Installation) and
Tire Pressure Monitoring System (TPMS) Rear Antenna (Removal and Installation).
- Check for correct installation of Initiator. Refer to:
- G4: CHECK FOR SHORT CIRCUIT IN INITIATOR HARNESS
- Locate and remove module blue connector L.
- Measure the resistance across the relevant initiator circuits within the blue connector.
Is the resistance less than 1 Ohm?
Yes
- A value of less than 1 Ohm indicates a short circuit, rectify the short circuit as required.
- No
: Install the correct tire low pressure sensor, of correct frequency, in accordance with that defined in the manufacturer approved diagnostic system new tire low pressure sensor application, to the position identified by the logged DTC.
Refer to: Tire Low Pressure Sensor (Removal and Installation).