LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2010 >> XFR >> Repair and Diagnosis >> External Pages >> Different car >> Section 179 (Starting System - GTDI 2.0L Petrol -- XF/X250) >> Starting System - GTDI 2.0L Petrol >> Description And Operation >> Starting System - System Operation And Component Description (G1550516) >> Description - Vehicles Without Stop/Start System >> Starter Motor

Starter Motor

WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
G11416474

The starter motor is located on the rear left side of the cylinder block and protrudes through an aperture to drive the drive plate via a ring gear. The motor is secured to the cylinder block by 2 bolts.

The power for starter operation is supplied on a substantial single cable connected direct from the battery positive terminal. At the battery end of this cable, located on the battery positive terminal, there is a starter fuse. In the event of fuse failure, the complete cable assembly must be replaced. The cable is connected to the solenoid via a copper threaded stud and secured with a nut. The solenoid power cable from the EJB is located adjacent to the power cable and is also attached to the solenoid via a copper threaded stud and nut.

scientia non olet · About LEMON Manuals