Fuel Rail Pressure Sensor (G1574132): Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Jaguar XFR, 2015 Jaguar XF, 2014 Jaguar XFR, 2014 Jaguar XF, and 2013 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Make sure that all openings are sealed. Use new blanking caps.
Make sure that the tools and equipment are clean, free of foreign material and lubricant.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions (General Information, Description and Operation).
Refer to: Fuel System Pressure Release - V6 S/C 3.0L Petrol/V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol (Fuel System - General Information, General Procedures).
Refer to: Fuel Injection Component Cleaning (Fuel Charging and Controls - V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol, General Procedures).
Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).
Refer to: Engine Cover - V8 S/C 5.0L Petrol (Interior Trim and Ornamentation, Removal and Installation).
Refer to: Secondary Bulkhead Right Panel - TDV6 3.0L Diesel/V6 S/C 3.0L Petrol/V8 S/C 5.0L Petrol (Front End Body Panels, Removal and Installation).
Vehicles with supercharger
CAUTION: Cap the coolant pipe ends immediately to minimize coolant loss.

Vehicles without supercharger
All vehicles
CAUTION: Be prepared to collect escaping fluids.

NOTE: During lubrication, keep the component vertically as shown.

Lubricate with Molykote W15 as shown.

Torque Specification: 38 Nm
NOTE:
- If equipped.
- During lubrication, keep the component vertically as shown.
Lubricate with Shell Ondina 933 as shown.

Torque Specification: 33 Nm