LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2010 >> XFR >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Engine - V6 S/C 3.0L Petrol -- XF/X250) >> Engine - V6 S/C 3.0L Petrol >> Oil Pan - RWD (G1774728) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: A new O-ring seal is to be installed.
    G11415783

    Torque Specification: 12 Nm 

  2. CAUTION:
    • Make sure that the mating faces are clean and free of foreign material.
    • Use only a plastic scraper when removing the sealing material.
    G11415784
    • Apply RTV sealant (Loctite 5901G) in a 2-3mm diameter to the areas shown, and tighten the bolts within 7 minutes.
  3. NOTE: Tighten the bolts in the indicated sequence.
    G11415785

    Torque Specification: 12 Nm 

  4. G11415786
  5. Refer to: Engine Oil Draining and Filling  (Engine - V6 S/C 3.0L Petrol, General Procedures).
  6. Connect the battery ground cable.

    Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).

scientia non olet · About LEMON Manuals