LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2010 >> XFR >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XF/X250) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Removal And Installation >> Left Mid Catalyst Heated Oxygen Sensor (G1557450) >> Installation

Left Mid Catalyst Heated Oxygen Sensor (G1557450): Installation

WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Make sure the anti-seize compound does not contact the HO2S tip.
  • If accidentally dropped or knocked install a new sensor.
  • Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals