Brake Lining and Disc Specifications

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Jaguar XFR-S, 2015 Jaguar XFR, 2015 Jaguar XF, 2014 Jaguar XFR-S, and 2014 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.

FRONT BRAKES	SPECIFICATION
Front brake pad material nominal thickness	12 mm (0.47 in)
Front brake pad material minimum thickness	2 mm (0.08 in)
Front disc diameter
2.2D and 3.0D low power output	326 mm (12.8 in)
2.0 GTDI, 3.0D high power output and 3.0 S/C	355 mm (14.0 in)
5.0 S/C all variants	380 mm (15.0 in)
Front disc thickness. Nominal/Minimum
2.2D and 3.0D low power output	Nominal 30 mm (1.18 in)/Minimum 27.3 mm (1.07 in)
2.0 GTDI, 3.0D high power output and 3.0 S/C	Nominal 32 mm (1.26 in)/Minimum 30 mm (1.15 in)
5.0 S/C all variants	Nominal 36 mm (1.42 in)/Minimum 33.3 mm (1.31 in)
Maximum front brake disc runout (installed)	0.075 mm (0.0029 in)
Maximum front hub face runout (installed)	0.0135 mm (0.0005 in)
Front calliper piston diameter
All variants except 5.0 S/C	60 mm (2.36 in)
5.0 S/C	42 mm (1.66 in) X 2
Front brake caliper bleed screw
All variants except 2.2D and 3.0D low power output	14 Nm (10 lb-ft)
2.2D and 3.0D low power output	8 Nm (6 lb-ft)
Rear brakes	Specification
Rear brake pad material nominal thickness	10 mm (0.39 in)
Rear brake pad material minimum thickness	2 mm (0.08 in)
Rear brake disc diameter
All variants except 5.0 S/C	326 mm (12.8 in)
5.0 S/C	376 mm (14.8 in)
Rear disc thickness. Nominal/Minimum
All variants except 5.0 S/C	Nominal 20 mm (0.79 in)/Minimum 17.3 mm (0.68 in)
5.0 S/C	Nominal 26 mm (1.02 in)/Minimum 23.3 mm (0.92 in)
Maximum rear brake disc runout (installed)	0.025 mm (0.0009 in)
Maximum rear hub face runout (installed)	0.0135 mm (0.0005 in)
Rear calliper piston diameter	45 mm (1.77 in)
Rear brake caliper bleed screw	14 Nm (10 lb-ft)