Front Driveshaft - AWD (G1578767): Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Jaguar XFR, 2015 Jaguar XF, 2014 Jaguar XFR, 2014 Jaguar XF, and 2013 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: It is possible to fit the driveshaft incorrectly. Note the orientation before removal.

NOTE:

A small amount of oil may weep from the driveshaft joints during storage. The loss of this oil will not affect the operation or durability of the joint.
Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: Air Deflector (501-02 Front End Body Panels, Removal and Installation).
CAUTION:
- Mark the position of the driveshaft flange in relation to the drive pinion flange.
- To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
- Remove the 6 Torx bolts and washers, discard the bolts.
CAUTION:
- Mark the position of the driveshaft flange in relation to the drive pinion flange.
- To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
- Remove the 6 Torx bolts and washers, discard the bolts.
- Compress the joints to disengage the drive flanges.
CAUTION: Extreme care must be taken when removing/installing the front driveshaft to ensure no stress or pressure is applied to the A/C pipe. Failure to follow this instruction may result in damage to the A/C pipe and/or joints.

Remove the front driveshaft.