LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2010 >> XFR >> Repair and Diagnosis >> Accessories & Equipment >> Window Motors & Regulators >> Glass, Frames And Mechanisms -- XF/X250 >> Glass, Frames And Mechanisms >> Diagnosis And Testing >> Glass, Frames And Mechanisms >> Manual SUNBLIND Initialization Routine

Manual SUNBLIND Initialization Routine

Where a sunblind module has been replaced, there is an initialization routine available on the diagnostic tool. This requires a new module to be initially installed in the fully down position and running of the "Initialize Specified Function/Feature" diagnostic routine on the manufacturer approved diagnostic tool. Alternatively, the sunblind may be initialized manually by following the procedures described below:

  1. Raise the sunblind to top (fully retracted) position
  2. Press and hold the door window 'down' switch for 15 seconds (the sunblind will go down and will then be in initialization mode)
  3. Release door window drop switch and press door window 'down' switch again to drive blind fully into lower block
  4. Activate window switch 'up' until the sunblind reaches the top (fully retracted) position and release switch
  5. The sunblind is now initialized and should have 'one-touch' functionality
scientia non olet · About LEMON Manuals