Rear Wheel Bearing (64.15.14): Installation
- Using the special tools, install the bearing to the wheel knuckle.
- Install the circlip.
- Using the special tools, install the wheel hub to the bearing.
- Install the wheel knuckle assembly.
- Tighten to 90 Nm.
- Attach the wheel knuckle to the halfshaft.
- Install the lower arm to the wheel knuckle.
- Install the outer tie rod retaining bolt.
- Install the ABS sensor.
- Tighten to 10 Nm.
- Install the brake disc.
For additional information, refer to
For additional information, refer to
For additional information, refer to BRAKE DISC - VEHICLES WITH: HIGH PERFORMANCE BRAKES, VIN RANGE: G00442->G45703 (70.10.10)
For additional information, refer to BRAKE DISC - VEHICLES WITH: HIGH PERFORMANCE BRAKES, VIN RANGE: G45704->G99999 (70.10.10)
- Tighten the wheel hub nut.
- Tighten to 300 Nm.
- Tighten to 150 Nm.
- Tighten to 55 Nm.
CAUTION:
The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.
NOTE:
Using the old wheel hub nut tighten to 150 Nm.
NOTE:
Remove and discard the old wheel hub nut, install a new wheel hub nut tighten to 150 Nm.
CAUTION:
The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.
CAUTION:
The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.