LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2009 >> XJ8 Base >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Acceleration Control (2003.5-09) >> Diagnosis and Testing >> Acceleration Control >> PINPOINT TEST G240070p2 : DTC P1122, P1123, P1215, P1216, P1344 >> G240070t6 : CHECK THE ACCELERATOR PEDAL DEMAND SENSOR CIRCUIT FOR A SHORT TO GROUND

G240070t6 : CHECK THE ACCELERATOR PEDAL DEMAND SENSOR CIRCUIT FOR A SHORT TO GROUND

  1. Disconnect the ECM electrical connector PI 1.
  2. Measure the resistance between electrical connector CA 88 pin 1 (O) and ground.
  3. Measure the resistance between electrical connector CA88 pin 4 (B) and ground.
    • Is the resistance greater than 10,000 ohms? 
  1. -> Yes :  GO to G240070t7 : CHECK THE ACCELERATOR PEDAL DEMAND SENSOR CIRCUIT FOR OPEN CIRCUIT .
  2. -> No :  REPAIR the accelerator pedal demand sensor circuit from the ECM to the accelerator pedal. CLEAR the DTC. TEST the system for normal operation.
scientia non olet · About LEMON Manuals