LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2008 >> XJR >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension (2003.5-09) >> Removal & Installation >> Air Suspension Control Module (60.32.03) >> Removal

Air Suspension Control Module (60.32.03): Removal

NOTE: Vehicles built before December 2003 have four suspension height sensors which are mounted on the front and rear subframe assemblies, two front and two rear. Vehicles built after December 2003 have only three (the right front sensor being deleted), although the functionality of the system remains the same.
NOTE: The later module can be fitted in place of the four sensor module, but the right front sensor must be left in place, even though the system will not use it.
    CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT .
  2. Remove the luggage compartment floor covering.
    • Remove the luggage compartment floor covering securing screws.
    • Remove the luggage compartment floor covering.
      Fig 1: Removing Luggage Compartment Floor Covering
      G03554199Courtesy of JAGUAR CARS, INC.
    3. NOTE: Left-hand shown, right-hand similar.
  3. Remove the luggage compartment side trim panel.
    • Remove the luggage compartment side trim retaining clip.
    • Remove the luggage compartment side trim panel.
      Fig 2: Removing Luggage Compartment Side Trim Panel
      G03554200Courtesy of JAGUAR CARS, INC.
  4. Remove the luggage compartment front carpet.
    1. Remove the fir tree clips
    2. Disconnect the interior light electrical connector.
    3. Remove the luggage compartment front carpet.
      Fig 3: Removing Luggage Compartment Front Carpet
      G03554201Courtesy of JAGUAR CARS, INC.
  5. Remove the rear seat backrest. For additional information, refer to REAR SEAT BACKREST (76.70.38) .
  6. Disconnect the air suspension control module electrical connectors.
    Fig 4: Disconnecting Air Suspension Control Module Electrical Connectors
    G03554202Courtesy of JAGUAR CARS, INC.
    7. NOTE: Clean the vehicle of any debris after the rivets have been removed.
  7. Remove the air suspension control module.
    • Using a suitable tool, remove the four rivets.
      Fig 5: Removing Four Rivets Using Suitable Tool
      G03554203Courtesy of JAGUAR CARS, INC.
scientia non olet · About LEMON Manuals