LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2008 >> XJR >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension (2003.5-09) >> Diagnosis And testing >> Vehicle Dynamic Suspension >> Pinpoint tests >> PINPOINT TEST G256924p5: B2807; PRESSURE SENSOR SIGNAL CIRCUIT FAULT >> G256924t8: CHECK THE PRESSURE SENSOR SIGNAL CIRCUIT FOR SHORT TO B+

G256924t8: CHECK THE PRESSURE SENSOR SIGNAL CIRCUIT FOR SHORT TO B+

  1. Disconnect the ASU electrical connector, CR88.
  2. Disconnect the valve block electrical connector, CR92.
  3. Measure the voltage between CR92, pin 02 (G) and GROUND.
    • Is the voltage greater than 3 volts? 
  1. -> Yes:  REPAIR the short circuit. For additional information, refer to the appropriate SYSTEM WIRING DIAGRAMS article. CLEAR the DTC. TEST the system for normal operation.
  2. -> No:  INSTALL a new valve block.
scientia non olet · About LEMON Manuals