G256924t7: CHECK THE SOLENOID DRIVE CIRCUIT FOR SHORT TO B+
- Disconnect the ASU electrical connector, CR91.
- Disconnect the valve block electrical connector, CR22.
- Measure the voltage between CR22, pin 05 (BO) and GROUND.
- Is the voltage greater than 3 volts?
- -> Yes: REPAIR the short circuit. For additional information, refer to the appropriate SYSTEM WIRING DIAGRAMS article. CLEAR the DTC. TEST the system for normal operation.
- -> No: Go to Pinpoint G256924t49: CHECK THE SOLENOID DRIVE CIRCUIT FOR SHORT TO GROUND .