LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2008 >> XJR >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension (2003.5-09) >> Diagnosis And testing >> Vehicle Dynamic Suspension >> Pinpoint tests >> PINPOINT TEST G256924p16: C1723; HEIGHT SENSOR(S) SUPPLY CIRCUIT(S) FAULT >> G256924t47: CHECK THE RIGHT-HAND REAR HEIGHT SENSOR SUPPLY CIRCUIT FOR HIGH RESISTANCE

G256924t47: CHECK THE RIGHT-HAND REAR HEIGHT SENSOR SUPPLY CIRCUIT FOR HIGH RESISTANCE

  1. Disconnect the right-hand rear height sensor electrical connector, CV04.
  2. Measure the resistance between CR90, pin 10 (YR) and CV04, pin 05 (YR).
    • Is the resistance greater than 5 ohms? 
  1. -> Yes:  REPAIR the high resistance circuit. For additional information, refer to the appropriate SYSTEM WIRING DIAGRAMS article. CLEAR the DTC. TEST the system for normal operation.
  2. -> No:  CHECK for DTCs indicating a sensor fault. Contact dealer technical support for confirmation of possible module failure, and/or raise an EPQR.
scientia non olet · About LEMON Manuals