G256924t29: CHECK THE REAR ACCELEROMETER SIGNAL CIRCUIT FOR SHORT TO GROUND
- Disconnect the ASU electrical connector, CR89.
- Disconnect the rear accelerometer electrical connector, TL34.
- Measure the resistance between TL34, pin 02 (GO) and GROUND.
- Is the resistance less than 10,000 ohms?
- -> Yes: REPAIR the short circuit. For additional information, refer to the appropriate SYSTEM WIRING DIAGRAMS article. CLEAR the DTC. TEST the system for normal operation.
- -> No: Go to Pinpoint G256924t30: CHECK THE REAR ACCELEROMETER SIGNAL CIRCUIT FOR SHORT TO B+ .