G240070t24 : CHECK CONTINUITY OF THE THROTTLE MOTOR RELAY GROUND CIRCUIT
- Disconnect the ECM electrical connector PI1.
- Measure the resistance between the throttle motor relay electrical connector FH 32D pin 2 (GR) and the ECM electrical connector PI1 pin 52 (GR).
- Is the resistance less than 5 ohms?
- -> Yes : DIAGNOSE the electronic engine control system. For additional information, refer to ELECTRONIC ENGINE CONTROLS - 3.5L/4.2L (2003.5-09) .
- -> No : REPAIR the throttle motor relay ground circuit from the ECM to the engine compartment fuse box. CLEAR the DTC. TEST the system for normal operation.