Brake Master Cylinder - Removal and Installation (RHD): Removal

CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

Remove the coolant expansion tank. Refer to Coolant Expansion Tank article.
Remove the brake fluid reservoir. See Brake Fluid Reservoir .

Courtesy of JAGUAR CARS, INC.
Release the plenum box sidewall.
- Remove the 4 bolts.
Courtesy of JAGUAR CARS, INC.
Remove the coolant expansion tank mounting bracket.
- Remove the 3 nuts.

NOTE: Some fluid spillage is inevitable during this operation.

Disconnect the brake master cylinder lines.

Courtesy of JAGUAR CARS, INC.

CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

Remove the brake master cylinder.
- Remove the 2 nuts.
Courtesy of JAGUAR CARS, INC.
Remove and discard the O-ring seal.