Parking Brake Release Actuator - VIN Range: G03446->H99999 (70.35.45): Removal
- Carry out the parking brake cable tension release.
For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE - VIN RANGE: G45704->G99999
- Drain the fuel tank.
For additional information, refer to FUEL TANK DRAINING - VIN RANGE: G45704->G99999 .
- Raise and support the vehicle.
For additional information, refer to JACKING AND LIFTING (2003.5-09) .
- Disconnect the parking brake release actuator electrical connector.
- Detach the air springs.
- Detach the fuel tank filler pipe.
- Detach the muffler and tail pipe from the hanger insulator.
- Install the special tool to support the rear subframe.
- Remove the noise, vibration and harshness brace retaining bolts.
- Remove and discard the rear subframe rear retaining bolts.
- Remove the noise, vibration and harshness brace.
- Remove and discard the rear subframe front retaining bolts.
- Lower the subframe to a maximum of 60 mm.
- Remove and discard the cross brace retaining bolts.
- Reposition the cross brace.
- Remove the parking brake release actuator retaining bolts.
- Detach the parking brake release actuator cable.
- Detach the parking brake release actuator cable.
- 1) For right-hand side connector bracket:
- Reposition the retaining tang.
- Detach the parking brake cable.
- 4) For left-hand side reaction bracket, detach the parking brake cable.
- 1) For right-hand side connector bracket:
- Remove the parking brake release actuator.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Right-hand shown, left-hand similar.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Left-hand shown, right-hand similar.