G531320t97: CHECK THE BRAKE SWITCH CIRCUIT FOR SHORT CIRCUIT TO POWER IN HARNESS
- Key off.
- Electric parking brake module connector 2 (CR32) disconnected.
- Key on, engine off.
- Make sure the brake pedal is not pressed.
- Measure the resistance between:CONNECTOR REFERENCE CHART
CR32 connector, harness side Vehicle battery Brake switch - signal - Pin 07 Positive terminal - Is the resistance greater than 100 Kohms?
- Yes: GO to Pinpoint Test G531320T98 .
- No: GO to Pinpoint Test G531320T99 .