Brake Caliper - Vehicles With: Standard Brakes, VIN Range: G00442->G45703 (70.55.03): Removal

Carry out the parking brake cable tension release procedure.
For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE - VIN RANGE: G00442->G45703
Remove both rear wheels and tires.
For additional information, refer to WHEEL AND TIRE (74.20.05) .
Detach the parking brake cable.
1. Reposition the brake caliper lever.
2. Detach the parking brake cable.
  
  Fig 1: Detaching Parking Brake Cable
  Courtesy of JAGUAR CARS, INC.
Detach the parking brake cable.
1. Release the retaining tangs.
2. Detach the parking brake cable.
  
  Fig 2: Detaching Parking Brake Cable
  Courtesy of JAGUAR CARS, INC.

CAUTION: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes. Wash hands thoroughly after handling, as prolonged contact may cause irritation and dermatitis. If brake fluid contacts the eyes, flush the eyes with cold water or eyewash solution and seek medical attention. If taken internally do not induce vomiting, seek immediate medical attention. Failure to follow these instructions may result in personal injury.

CAUTION: If brake fluid comes into contact with the paintwork, the affected area must be immediately washed down with cold water.

CAUTION: The brake caliper must be supported at all times.

CAUTION: Cap the brake hose to prevent loss of fluid and prevent dirt ingress.

NOTE: To prevent the loss of brake fluid, apply the brake pedal hold-down tool and adjust to hold the brake pedal down 40 mm (1.6 in).

Detach the brake hose.
- Remove and discard the sealing washers.
  
  Fig 3: Locating Sealing Washers
  Courtesy of JAGUAR CARS, INC.

NOTE: Left-hand shown, right-hand similar.

Remove the brake caliper.
1. Remove and discard the brake caliper retaining bolts.
2. Remove the brake caliper.
  
  Fig 4: Locating Brake Caliper Retaining Bolts
  Courtesy of JAGUAR CARS, INC.