Upper Arm (64.25.31): Installation

CAUTION: The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.

Install the upper arm.

Fig 1: Locating Upper Arm Bolts
Courtesy of JAGUAR CARS, INC.

CAUTION: The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.

Fig 2: Locating Wheel Knuckle Bolt

Courtesy of JAGUAR CARS, INC.

Attach the upper arm to the wheel knuckle.
Attach the anti-lock brake system (ABS) sensor wiring harness.

Fig 3: Locating Anti-Lock Brake System (ABS) Sensor Wiring Harness
Courtesy of JAGUAR CARS, INC.
Attach the high intensity discharge (HID) sensor link rod.

Fig 4: Locating High Intensity Discharge (HID) Sensor Link Rod
Courtesy of JAGUAR CARS, INC.
Install the wheel and tire. Refer to WHEEL AND TIRE (74.20.05) .
Lower the vehicle.
CAUTION: The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.
Tighten to 98 Nm.

Fig 5: Locating Upper Arm Bolts
Courtesy of JAGUAR CARS, INC.

CAUTION: The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.

Fig 6: Locating Wheel Knuckle Bolt

Courtesy of JAGUAR CARS, INC.

Tighten to 90 Nm.
Check and adjust the wheel alignment as necessary. Refer to SUSPENSION SYSTEM-GENERAL INFORMATION (2003.5-09) .