LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2005 >> XJR >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake (2003.5-09) >> Removal and Installation >> Brake Disc - Vehicles With: Standard Brakes, VIN Range: G00442->G45703 (70.10.11) >> Removal

Brake Disc - Vehicles With: Standard Brakes, VIN Range: G00442->G45703 (70.10.11): Removal

  1. Remove the brake pads.

    For additional information, refer to BRAKE PADS - VEHICLES WITH: STANDARD BRAKES, VIN RANGE: G00442->G45703 (70.40.03) 

  2. CAUTION: The brake caliper must be supported at all times.
    Fig 1: Locating Brake Caliper Anchor Plate Bolts
    G06387550Courtesy of JAGUAR CARS, INC.
  3. Detach brake caliper anchor plate.
  4. NOTE: If the same brake disc is to be installed, the tip of a hub must be marked with a corresponding part of the brake disc for alignment.
  5. Remove the brake disc.
    • Remove and discard the brake disc retaining clips.
      Fig 2: Locating Brake Disc Retaining Clips
      G06387551Courtesy of JAGUAR CARS, INC.