Air Suspension Solenoid Valve Block: Removal
- Using the Jaguar approved diagnostic system depressurize the air suspension system.
- Disconnect the battery ground cable. Refer to BATTERY DISCONNECT .
- Remove the luggage compartment floor covering.
- Remove the luggage compartment floor covering securing screws.
- Remove the luggage compartment floor covering.
- Remove the spare wheel.
- Remove the reservoir insulator.
- Disconnect the electrical connector.
- Disconnect the electrical connector.
- Remove the air pipes.
- Detach the blue air pipe.
- Detach the white air pipe.
- Detach the yellow air pipe.
- Detach the red air pipe.
- Detach the brown air pipe.
- Detach the pink air pipe.
- Remove the solenoid valve block.
CAUTION:
Before the spare wheel retainer is removed the lower locking nut should be loosened.
WARNING:
Loosen the pipes no more than one full turn to allow the stored air pressure to vent for a minimum of three seconds.
WARNING:
Loosen the pipe no more than one full turn to allow the stored air pressure to vent for a minimum of one minute.