LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2005 >> XJ8 L >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension (2003.5-09) >> Diagnosis And testing >> Vehicle Dynamic Suspension >> Pinpoint tests >> PINPOINT TEST G256924p15: C1460; ACCELEROMETER SENSOR SUPPLY CIRCUIT FAULT >> G256924t35: CHECK THE ACCELEROMETER SENSOR SUPPLY CIRCUIT FOR HIGH RESISTANCE

G256924t35: CHECK THE ACCELEROMETER SENSOR SUPPLY CIRCUIT FOR HIGH RESISTANCE

  1. Disconnect the front accelerometer electrical connector, EC13.
  2. Disconnect the rear accelerometer electrical connector, TL34.
  3. Measure the resistance between CR91, pin 16 (Y) and EC13, pin 03 (Y).
  4. Measure the resistance between CR91, pin 16 (Y) and TL34, pin 03 (Y).
    • Is either resistance greater than 5 ohms? 
  1. -> Yes:  REPAIR the high resistance circuit. For additional information, refer to the appropriate SYSTEM WIRING DIAGRAMS article. CLEAR the DTC. TEST the system for normal operation.
  2. -> No:  CHECK for DTCs indicating a sensor fault. Contact dealer technical support for confirmation of possible module failure, and/or raise an EPQR.
scientia non olet · About LEMON Manuals