Parking Brake Release Actuator - VIN Range: G00001->G03445 (70.35.45): Installation

NOTE: Make sure the parking brake cable is correctly routed.

To install, reverse the removal procedure.
- Tighten to 20 Nm.
  
  Fig 1: Locating Parking Brake Release Actuator Retaining Bolts
  Courtesy of JAGUAR CARS, INC.

CAUTION: Calibrate the electric park brake using Jaguar approved diagnostic system. If the Jaguar approved diagnostic system is not available disconnect the battery for approximately 30 seconds, the vehicle will then prompt the driver to carry out the calibration procedure as per the vehicle hand book on re-connection.

Calibrate the electric parking brake module using the Jaguar approved diagnostic system.