Special Service Tools

Fig 1: Identifying Electric Parking Brake Release Tool (206-082)

Courtesy of JAGUAR CARS, INC.

Electric parking brake release tool 206-082

Fig 2: Identifying Electric Parking Brake Release Tool (206-082-01)

Courtesy of JAGUAR CARS, INC.

Electric parking brake release tool 206-082-01

WARNING: Always use the Jaguar Approved Diagnostic System to release the parking brake cable tension, when carrying out repair operations on the electric park brake which require the cable tension to be released.
WARNING: The procedure below should only be used in emergency situations, to release the electric parking brake. All calibration of the parking brake system will be lost, and the parking brake will need to be re-calibrated to function correctly.
NOTE: The tool shown must only be used in the event of an emergency.
1. Connect the Jaguar approved diagnostic system to release the parking brake cable tension.
2. Move the selector lever to the ' P' position.
3. Release the parking brake.
4. Remove the luggage compartment floor covering.
   Fig 3: Locating Luggage Compartment Floor Covering

   Courtesy of JAGUAR CARS, INC.
5. Remove the luggage compartment side trim panel.
   Fig 4: Locating Luggage Compartment Side Trim Panel

   Courtesy of JAGUAR CARS, INC.
6. Detach the rear electronic module (REM).
   Fig 5: Locating Rear Electronic Module (REM)

   Courtesy of JAGUAR CARS, INC.
CAUTION: Disconnect the parking brake module electrical connectors in the sequence shown. Failure to follow this instruction may result in diagnostic trouble codes being stored in the module.
Fig 6: Locating Parking Brake Module Electrical Connectors
Courtesy of JAGUAR CARS, INC.
7. Disconnect the parking brake module electrical connectors.
8. Connect the special tools to the parking brake module wiring harness electrical connectors.
   Fig 7: Connecting Special Tools To Parking Brake Module Wiring Harness Electrical Connectors

   Courtesy of JAGUAR CARS, INC.
NOTE: Operate the parking brake release tool until an audible noise is heard from the parking brake release actuator.
Fig 8: Releasing Parking Brake Cable Tension
Courtesy of JAGUAR CARS, INC.
9. Release the parking brake cable tension.
10. Remove the special tool and carry out any necessary repair to the system.
11. Disconnect the special tools from the parking brake module wiring harness electrical connectors.
    Fig 9: Disconnecting Special Tools From Parking Brake Module Wiring Harness Electrical Connectors

    Courtesy of JAGUAR CARS, INC.
CAUTION: Connect the parking brake module electrical connectors in the sequence shown. Failure to follow this instruction may result in diagnostic trouble codes being stored in the module.
Fig 10: Locating Parking Brake Module Electrical Connectors
Courtesy of JAGUAR CARS, INC.
12. Connect the parking brake module electrical connectors.
13. Attach the REM.
    • Tighten to 6 Nm.
      Fig 11: Identifying Rear Electrical Module (REM)

      Courtesy of JAGUAR CARS, INC.
14. Install the luggage compartment side trim panel.
    Fig 12: Locating Luggage Compartment Side Trim Panel

    Courtesy of JAGUAR CARS, INC.
15. Install the luggage compartment floor covering.
    Fig 13: Locating Luggage Compartment Floor Covering

    Courtesy of JAGUAR CARS, INC.
NOTE: The brake pedal must be applied when calibrating the parking brake switch.
16. Apply the parking brake.
CAUTION: Calibrate the electric park brake using Jaguar approved diagnostic system. If the Jaguar approved diagnostic system is not available disconnect the battery for approximately 30 seconds, the vehicle will then prompt the driver to carry out the calibration procedure as per the vehicle hand book on re-connection.
17. Calibrate the electric parking brake module using the Jaguar approved diagnostic system.