Service brake incorrectly adjusted following lining change
Caliper malfunction
Actuator malfunction
Check the rear and primary cables for fouling, trapping or damage
Check the cable routing between caliper and subframe mountings. Make sure the cables sit above the rear anti-roll bar drop link caps, and that the drop link caps are not damaged
Check that the rear cable end fitting connector is correctly fitted into the caliper bracket, and is not damaged
Check that the rear cable end fitting connector is correctly fitted into the subframe bracket and is not damaged
Check the 'C' clip between the cable and the subframe for fit/damage
Check that the cable is correctly located into the reaction and connector brackets
Inspect the rear brake linings (parkbrake caliper linings for vehicles with supercharger) for wear
Check the parkbrake cable for correct adjustment
Fully retract the cables. Pump the brake pedal hard five times
Check the condition of the rear caliper (parkbrake caliper for vehicles with supercharger). Make sure the caliper return spring is correctly fitted
Check the actuator for damage and/or excessive noise in normal operation