Brake Fluid Reservoir: Installation
- Install seals into master cylinder.
- Remove plugs.
- Lubricate seals with clean brake fluid.
- Install seals.
Courtesy of JAGUAR CARS, INC.
- Install reservoir to master cylinder.
- Remove plugs.
- Install reservoir, making sure reservoir is fully seated.
- Install locating pin.
Courtesy of JAGUAR CARS, INC.
- Install pedal housing, brake booster and master cylinder assembly. Refer to BRAKE PEDAL AND BRACKET, BRAKE BOOSTER AND BRAKE MASTER CYLINDER
.
- Install engine compartment rear cover.
- Reconnect battery ground cable. (IMPORTANT, see BATTERY GROUND CABLE
for further information).
- Bleed brake system. Refer to BLEEDING BRAKE SYSTEM
.
- Remove paint-work protection covers and close engine compartment.