LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 1998 >> XJR >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> "A" Frame (1998) >> Installation

"A" Frame (1998): Installation

  1. Place and install "A" frame to final drive unit casing securing bolts, DO NOT fully tighten. Install "A" frame to final drive unit front bracket and tie rod outer securing bolts with captive spacers. DO NOT fully tighten. Install "A" frame to final drive unit front bracket securing bolts.
  2. Install "A" frame to final drive unit front bracket inner securing nuts and bolts. DO NOT finally tighten. Install and tighten "A" frame to final drive unit rear bracket securing bolts. See TORQUE SPECIFICATIONS .
  3. Fully tighten "A" frame to final drive unit front bracket and tie rod outer securing bolts, intermediate securing bolts, inner securing nuts and bolts. See TORQUE SPECIFICATIONS . Finally tighten "A" frame to final drive unit casing securing bolts. See TORQUE SPECIFICATIONS .
  4. Position one of outer bush brackets and raise bottle jack ram approximately 25 mm to seat "A" frame outer bushes onto tapered body locations. Install outer bush securing bolts, DO NOT tighten. Align and install outer bush bracket to body securing bolts, DO NOT tighten. Repeat procedure for remaining outer bush bracket. 5) Finally tighten outer bush bracket to body securing bolts of both outer bush brackets and both outer bushes. See TORQUE SPECIFICATIONS . To complete installations, reverse removal procedure.
scientia non olet · About LEMON Manuals