LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 1995 >> XJ12 >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Hub Carrier >> Bearing Replacement (Fulcrum Pivot)

Bearing Replacement (Fulcrum Pivot)

  1. Clamp hub carrier in vise. Using a drift, remove fulcrum shaft components. See Figure. Fit Extractor (18G 284 AAH) behind bearing race. Install slide hammer to extractor and remove bearing race. Loosen, but DO NOT remove, extractor cross bolt. Remove remaining bearing race in same manner.
  2. Clean and inspect all parts. Replace parts as needed. Pack bearings with axle bearing grease. Install bearing and fully seat bearing races using Handle (18G 134) and Race Installer (JD 550-6).
  3. Using equal thickness shims, obtain bearing preload of .003" (.08 mm). To complete assembly, reverse disassembly procedure.
scientia non olet · About LEMON Manuals