Center Vent Vacuum Solenoid
Center Vent Vacuum SolenoidRemoval
1. Open the bonnet and disconnect the battery earth lead.
2. Open the car door and remove the right hand side dash liner and the footwell outlet duct.
3. Remove the two screws securing the solenoid mounting panel and displace the panel for access.
4. Note their positions, then disconnect the vacuum hoses and supply cables.
5. Remove the solenoid assembly.
6. Remove the vacuum elbow tube and the black vacuum tube.
7. Release the solenoid mounting clips and remove the centre vent solenoid.
Installation
- Install in the reverse of the removal procedure.