Disc Specifications:

^ Minimum run-out: .004" (measured at outer edge of ribbed area)

^ Minimum thickness: Front Rear

Sedan 88/89 MY 21 mm (0.825") 8.8 mm (0.345")
Sedan 90/91 MY 27 mm (1.060") 8.8 mm (0.345")
Series III/XJ-S 22.9 mm (0.90") 11.4 mm (0.45")


When replacing pads:

^ ONLY use Jurid 518 pads when replacing brake pads.

^ Install axle sets (when Jurid pads are installed)

^ Install complete vehicle set (when Jurid pads are not installed).


NOTE: When installing wheels ALWAYS use a torque wrench for the wheel nuts. Tighten to 65-75 ft. lbs. (88-102 N-m).