Automatic Transmission

STANDARD FINISHER

RENEW

- Remove console ashtray. Service and Repair

- Using a screwdriver; release the gearshift rubber surround locating clips and carefully remove the finisher.





- Move the selector lever to the rearward position, remove the wingnuts securing the rear of the veneer, and carefully remove the finisher (Fig. 1). Fitting is the reversal of this procedure.

AUTOMATIC GEARBOX SELECTOR TRIM FINISHER

Renew

- Disconnect vehicle battery earth.

- Remove gearbox sport mode switch.

- Remove gearbox sport mode switch finisher.





- Remove the trim finisher (Fig. 1).

- Fitting is the reversal of this procedure.