Section A

SECTION A - Replacement of Ignition and Glove Box Locks:

Ignition Lock -

The ignition lock is not serviceable. If the lock has failed, install a slave lock until the coded replacement is received. If the lock has not failed but occasionally sticks, order a coded replacement and install when available.

The order for a coded ignition lock should be submitted to your Zone Parts Department as a V.O.R. request with the following information:

^ Key Code
^ Barrel Assembly JLM 1983 (replacement lock)

Glove Box Lock -

This lock is also not serviceable and must be replaced as a unit. A slave lock barrel is not available.

The order for a coded glove box lock should be submitted to your Zone Parts Department as a V.O.R. request with the following information:

^ Key Code
^ Lock BEC 1395 (replacement lock)