Recirculation/Fresh Air Vacuum Solenoid

Recirculation/Fresh Air Vacuum Solenoid

Removal
1. Open the bonnet and disconnect the battery earth lead.
2. Open the car door and remove the left hand side dash liner and the footwell outlet duct
3. Remove the screws securing the solenoid mounting panel and displace the panel for access.
4. Note then disconnect the vacuum hoses and the supply cables.
5. Remove the vacuum solenoid assembly.
6. Remove the screw securing the solenoid to the mounting plate.
7. Disconnect the blue vacuum hose and remove the solenoid.

Installation
- Installation is the reverse of the removal procedure.