Rear Door Panel: Service and Repair

RENEW

- Open the door.





- Hold inner door handle in the open position and remove inner handle escutcheon plate blank (1, Fig. 1).

- Remove the screw (2, Fig. 1) securing the escutcheon plate (3, Fig. 1), remove the plate and gasket.

- Carefully pull the veneer panel (4, Fig. 1) to release the retaining clips.

- Remove the screws securing the retaining clip and remove the retaining clip assemblies.

- Discard the veneer panel.

- Fitting is the reversal of this procedure.