Rear Suspension Assembly: Removal
- Raise and support vehicle. Remove wheel assemblies. Place floor jack (with adaptor to hold suspension assembly) under rear suspension.
- Disconnect intermediate exhaust pipes at both ends and remove. Support rear mufflers out of way. Disconnect radius arm-to-body mounting hardware.
- Separate brake line union from body bracket. Disconnect brake lines at flexible hoses and plug. Disconnect drive shaft at differential and lower out of way.
- Release parking brake. Disconnect parking brake cable from junction at rear suspension assembly. Remove suspension bracket nuts. Lower suspension assembly to floor and slide from vehicle.
NOTE:
Replace suspension bushings in pairs.