Lower Control Arm: Removal
- Raise vehicle and support with safety stands, forward of radius arms. Remove wheel assembly.
- Remove lock nut and drive out bearing carrier fulcrum shaft. Fit dummy shaft for support. Collect shims and all seal retainers.
- Lift bearing carrier up, clear of control arm. Keep carrier in position with heavy wire attached to the crossmember. Separate radius arm from body.
- Remove bolts attaching support plate to the crossmember and inner fulcrum brackets. Separate shock absorber at upper mount. Drive out pivot pin.
- Separate inner fulcrum from control arm. Remove control arm and radius arm.