Removal & Installation (XKE)

Disconnect battery, remove reserve tank, window washer reservoir and bracket. Remove slave cylinder reservoir and left hand air cleaner. Remove fluid line from master cylinder outlet and replace bolt. Remove fuel line clip and pull off flex hose. Disconnect vacuum hoses from servo. Remove nuts securing brake master cylinder to pedal box. Withdraw master cylinder from mounting and tie to one side. Disconnect fluid lines on slave cylinder and plug ends. Remove fluid feed hose from top of slave cylinder. Inside vehicle, pull carpet from left hand front floor panel. Remove floor insulation material and floor panel cover. Remove fasteners from slave cylinder bracket and remove servo. To install, reverse removal procedure and bleed brake system.