Removal & Installation (XJ6 & XJ12)

Remove right air cleaner and disconnect choke cable from right-front carburetor. Disconnect hydraulic lines and vacuum line. Disconnect electrical leads from fluid level warning switch. Remove reservoir and bracket assembly from pedal box. Remove nuts securing pedal box vertical mounting to firewall, lift heater vacuum pipe clear of studs, remove brake light switch, and remove bolts securing pedal box base mounting to firewall. Lift out pedal box, servo unit, and master cylinder as an assembly. Remove nuts securing servo to pedal box, remove rubber sealing plugs and remove clevis pin connecting servo operating rod to brake pedal lever. To install, reverse removal procedure and bleed hydraulic system.