Disc Pads (Service Brakes): Installation
Draw out about half the brake fluid from reservoir(s). This will enable caliper pistons to be pushed back into cylinders without overflowing fluid. Lever pistons back, insert new pads, springs and replace retaining pins and clips. Check pads for freedom of movement within caliper. Check reservoirs for correct fluid level.
Draw out about half the reservoir fluid if pistons are to be pushed back within cylinders. Install new pads, pins, and clips. Clean old sealer from inspection covers and apply suitable waterproof sealer. Install new gaskets and secure bolts. Replace seat cushion and check reservoir fluid level.