Brake Rotor: Installation

Mount rotor to hub, pack bearings with suitable grease and install hub fasteners. Set hub end play within specification and check rotor runout. Install caliper and bleed brakes.

Position rotor against differential shaft flange and tap through bolts. Reinstall same camber shims removed during disassembly on flange bolts. Secure half shaft universal joint flange to differential flange using four new self-locking nuts. Check brake rotor runout, limit is 0.006" (0.15 mm). Reinstall universal joint shield, springs, shock absorber, and caliper. Use feeler gauges to check rotor for center between caliper halves. If necessary to recenter rotor, remove caliper, rotor and place required shims between drive flange and rotor. Reinstall rear suspension system, check rear wheel camber and adjust if necessary.