LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Information >> Vent Hose Replacement (2WD) >> Installation Procedure

Installation Procedure

    Fig 1: Transmission Vent Hose Retainer At Transmission Housing
    GM2007884Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Ensure the vent is not plugged.
    • Route the vent hose the same way as removed.
    • Ensure the vent hose is free of kinks and is routed clear of sharp objects.
  1. Connect the transmission vent hose (2) to the vent pipe.
  2. Connect the transmission vent hose retainer (1) to the transmission housing.
    3. Fig 2: Transmission Vent Hose Retainer At Tail Housing Bracket
    GM2007886Courtesy of GENERAL MOTORS CORP.
  3. Connect the transmission vent hose retainer (1) to the transmission tail housing bracket.
    4. Fig 3: Transmission Vent Hose Retainer At Transmission Support
    GM2007888Courtesy of GENERAL MOTORS CORP.
  4. Connect the transmission vent hose retainer (1) to the transmission support.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals