LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Information >> Transmission Mount Replacement (4WD) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Transmission Mount
    GM1201366Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts.

    Tighten:  Tighten the bolts to 55 N.m (41 lb ft).

  3. Install the transmission support. Refer to Transmission Support Crossmember Replacement (2WD) or Transmission Support Crossmember Replacement (4WD) .
scientia non olet · About LEMON Manuals