LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Information >> Transmission Mount Replacement (2WD) >> Installation Procedure

Installation Procedure

    Fig 1: Transmission Mount, Spacer And Bolts
    GM2007877Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount spacer (2).
  2. Install the transmission mount spacer bolts (1).
  3. Install the transmission mount (3).
    4. NOTE: Refer to Fastener Notice .
  4. Install the bolts (4).

    Tighten:  Tighten the bolts to 55 N.m (41 lb ft).

    5. Fig 2: View Of Transmission Support
    GM1235550Courtesy of GENERAL MOTORS CORP.
  5. Lower the transmission and install the 2 nuts securing the transmission mount to the transmission support.

    Tighten:  Tighten the nuts to 57 N.m (42 lb ft).

  6. Remove the transmission jack.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals