LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
    2. Fig 1: Manual Shift Detent Lever with Shaft Position Switch Assembly
    GM2035543Courtesy of GENERAL MOTORS CORP.
  2. Remove the following parts: (89), (92), (88), (85) and (84)
    3. Fig 2: Identifying Manual Shaft Seal
    GM59273Courtesy of GENERAL MOTORS CORP.
  3. Remove the manual shaft seal (82) with a screwdriver.
scientia non olet · About LEMON Manuals