LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Rear Seat Back Cushion Frame Replacement (Crew Cab) >> Removal Procedure

Removal Procedure

  1. Remove the seat from the vehicle. Refer to Rear Bench Seat Replacement .
  2. Remove the rear head rest restraints, if equipped. Refer to Rear Seat Head Restraint Replacement .
    3. Fig 1: View Of Seat Cushion Frame Side Trim Covers
    GM1361325Courtesy of GENERAL MOTORS CORP.
  3. Remove the screw securing the side trim covers to the seat cushion frame.
  4. Remove the seat back cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement (Crew Cab) .
    5. Fig 2: View Of Head Restraint
    GM1361341Courtesy of GENERAL MOTORS CORP.
  5. Remove the head restraint guides from the seat back frame by pinching the tabs on the guides and pulling the guides out of the frame.
  6. Remove the seat back latch assembly. Refer to Rear Seat Back Latch Replacement .
    7. Fig 3: View Of Seat Back Frame To Seat Cushion Frame Bolt
    GM1361333Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolt securing the seat back frame to the seat cushion frame.
    8. Fig 4: View Of Seat Back Frame - Crew Cab
    GM1361350Courtesy of GENERAL MOTORS CORP.
  8. Remove the seat back frame by pulling the frame off the seat cushion frame stud.
  9. Inspect the white nylon bushing on the seat back frame for wear or damage and replace if necessary.
scientia non olet · About LEMON Manuals