LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Rear Seat Back Cushion Frame Replacement (Crew Cab) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Seat Back Frame - Crew Cab
    GM1361350Courtesy of GENERAL MOTORS CORP.
  1. Install the seat back frame by pushing the frame onto the seat cushion frame stud.
    2. Fig 2: View Of Seat Back Frame To Seat Cushion Frame Bolt
    GM1361333Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the bolt securing the seat back frame to the seat cushion frame.

    Tighten:  Tighten the rear bench seat back frame mounting bolt to 50 N.m (37 lb ft).

  3. Install the seat back latch assembly. Refer to Rear Seat Back Latch Replacement .
    4. Fig 3: View Of Head Restraint
    GM1361341Courtesy of GENERAL MOTORS CORP.
  4. Install the head restraint guides in the seat back frame by pushing the guides through the frame until the tabs lock into place.
  5. Install the seat back cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement (Crew Cab) .
    6. Fig 4: View Of Seat Cushion Frame Side Trim Covers
    GM1361325Courtesy of GENERAL MOTORS CORP.
  6. Install the screw securing the side trim covers to the seat cushion frame.

    Tighten:  Tighten the rear bench seat side trim cover screw to 1.5 N.m (13 lb in).

  7. Install the rear head rest restraints, if equipped. Refer to Rear Seat Head Restraint Replacement .
  8. Install the seat from the vehicle. Refer to Rear Bench Seat Replacement .
scientia non olet · About LEMON Manuals