Removal Procedure
- Remove the seat from the vehicle. Refer to Front Seat Replacement - Bucket or Split Bench Seat Replacement .
Courtesy of GENERAL MOTORS CORP.
- Unclip the front, rear, and side J-strips (1, 2) on the underside of the seat.
- Remove the lumbar knob by pulling the knob straight away from the seat, if equipped.
- Remove the recliner handle. Refer to Driver Seat and Passenger Seat Recliner Handle Replacement .
Courtesy of GENERAL MOTORS CORP.
- Remove the screws (2) that retain the lumbar adjustment mechanism (1) to the seat adjuster.
- Remove the lumbar cable from the lumbar adjustment mechanism.
Courtesy of GENERAL MOTORS CORP.
- Remove the 2 bolts (1) securing the seat recliner to the seat adjuster.
- Remove the seat back assembly from the seat cushion assembly.
Courtesy of GENERAL MOTORS CORP.
- Disconnect the seat belt buckle electrical connector (1).
- Disconnect the wiring harness (2) from the seat position switch.
Courtesy of GENERAL MOTORS CORP.
- Remove the bolt (2) securing the seat belt buckle assembly (1) to the seat adjuster.
- Remove the seat cushion cover and foam.
- Remove the assist spring.
Courtesy of GENERAL MOTORS CORP.
- Remove the 4 nuts (1) securing the seat cushion frame to the seat adjusters.
- Remove the seat adjusters.
Courtesy of GENERAL MOTORS CORP.
- Remove the 2 nuts (1) securing the seat position switch (3) to the seat adjuster (2).